Stainless steel float switch

Liquid level float switch functions :

Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch's water supply control, automatic pump shutdown when water is full

Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch's drainage control, automatic pump shutdown after drainage

Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch's water shortage protection, protect the water pump from dry burning

Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch's​​​​​​​ up and down joint, simultaneous control of upper and lower water tanks

Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch's​​​​​​​​​​​​​​ position of the heavy hammer is installed at approximately 1/2 of the water level that Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch​​​​​​​ needs to be controlled.

For example, if a user's water tank is 2 meters long and Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch​​​​​​​ needs to be filled with water,  which will automatically shut off the Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch​​​​​​​ ​​​​​​water supply. If the Liquid level float switch and Stainless steel high-tech anti corruption.mechanical float switch​​​​​​​ motor power is 350W, then the float switch heavy hammer can be installed at a distance of 1 meter and the wire is connected to the"black blue"control

Placement method of float switch heavy hammer

1. Thread the wire of the float switch through the concave circular hole in the center of the heavy hammer, and gently push the heavy hammer to make the plastic ring embedded above the circular hole fall off due to the pushing force of the wire head

If necessary, you can also use a screwdriver to remove this plastic ring. Then, put the detached plastic ring on the cable to set the water level as you want with a weight hammer

2. Gently push the heavy hammer to pull out the cable until the center of the heavy hammer grips the plastic. As long as the heavy hammer is lightly fastened in the plastic ring, it will not slip off. If the plastic ring is damaged or lost, it can be replaced with a bare copper wire fastened into the cable. Please purchase the corresponding meter according to your needs, which can be directly pulled into the control box. Try to avoid using intermediate joints as much as possible. If there is a joint due to necessity, do not immerse the cable joint in water.